Acquire™ is a trademark of Ambrit Ltd
© 2019 Ambrit Ltd
This is an optional feature and will only be available if it has been licensed in the key file.
This will open the Batch Schedule screen.
Tip: More than one batch report can be added to the reports list. Go to the batch settings screen to define your own reports.
|Density / SG60||This is the sampled density results. If a value is entered it will recalculate the Gravity (API60) field. The units are defined in the Batch Settings screen.|
|BS&W||This is the sampled BS&W results. The units are defined in the Batch Settings screen.|
|Gravity (API60)||This is the sampled gravity results. If a value is entered it will recalculate the Density / SG60 field. The units are defined in the Batch Settings screen.|
This will send the new sample results down to the flow computer. The flow computer will use these values to recalculate the batch results and a new batch will be generated. Acquire will treat this as a new revision to the original batch.
For batch recalculation to work the original batch must still reside in the flow computer otherwise it will be rejected.
Warning: Batch recalculation has only limited support in the Omni. Batch recalculation will depend on the Omni firmware as to the capabilities provided. It is recommended that recalculation is only used with 20.75.x or 24.75.x. versions.
The status will momentarily go to “Recalculating” before going to “Complete”. A new revision for the batch including the reports will be generated.