Acquire must be in Config mode to perform these steps.
Warning: This section describes how the flow works in Acquire and provides a worked example which will overwrite your changes. Do not follow this example on a production database.
A blank P&ID will be displayed:
The Device Properties window will be displayed:
Flow will always start from an inlet interface.
Note: Default subtypes act as both an inlet and outlet interface.
The inlet will be added to the P&ID:
The Device Properties window will be displayed:
Flow will always end at an outlet interface.
Note: Default subtypes act as both an inlet and outlet interface.
The outlet will be added to the P&ID:
When the inlet and outlet are connected the P&ID will flow:
All flow is disrupted by a valve that is closed or illegal. To enable flow set up the valve.
A P&ID can have multiple inlets and outlets.
Note: Tank devices act as both inlets and outlets.