Configurations

• Introduction

  ( Configurations )

  Configurations are at the heart of Profile. Every RTU on the system is assigned a configuration that describes the communications, alarms, screens and reports.     Configurations can be shared between multiple RTUs that are set up in the same … Continue reading →

• Adding a Configuration

  ( Configurations )

  There are two ways to add a configuration. The recommended way is to add a configuration while adding the RTU itself. See the ‘Adding an RTU‘ section for more information. Alternatively, generic RTU configurations can be created directly from the … Continue reading →

• Deleting a Configuration

  ( Configurations )

  The configuration cannot be deleted if there are RTUs using it. In this situation the RTUs must be removed first. Warning: Once the configuration has been deleted it cannot be recovered.  1. Select ‘Configurations…’ from the ‘Config’ menu 2. Single click a configuration … Continue reading →